| H2-ERM100 / H4-ERM100 Revision History | ||||
|
Firmware Version |
Boot Loader Version |
Date | Applies To: | Description of Problems / Additions / Changes |
| 7.0.1001 | 7.0.3 | 12-Jun-2019 | H2-ERM100 |
This is the minimum firmware and boot loader versions required for
H2-ERM100 with Rev 8A hardware.
Requires the use of
NetEdit v3.17a or later. |
| 4.0.118 | 5.0.84 | 24-Apr-2014 | H2-ERM100 H4-ERM100 |
Fixed a problem where the ERM100 would not clear the Slave
Error bits when the error condition in the slave was resolved. |
| 4.0.117 | 5.0.84 | 11-Nov-2013 | H2-ERM100 H4-ERM100 |
Fixed a problem where the ERM100 would try to process a
PRINT command if it was in Debug (test) mode. Doing so would cause
sporadic scan times in the ERM100. |
| 4.0.116 | 5.0.84 | 01-Jul-2013 | H2-ERM100 H4-ERM100 |
Fixed a problem where the ERM100 was improperly handling
an error in normal communications shortly after power-up (about 5-10
seconds). |
| 4.0.82 | 5.0.84 | 18-Mar-2013 | H2-ERM100 H4-ERM100 |
Fixed a problem where NetEdit could not update the firmware
in either ERM100. |
| 4.0.80 | 5.0.84 | 26-Feb-2013 | H2-ERM100 H4-ERM100 |
Fixed a problem where full duplex mode was not correctly
setup. Fixed a problem that was wrongly causing some backplane retries. Fixed a problem in the FPGA code (h/w version 5BB)
that caused the ERM100 to drop some packets on networks with high packet
volume, which created a large number of retries. |
| 4.0.73 | 5.0.84 | 21-Feb-2013 | H2-ERM100 H4-ERM100 |
Initial Release of
H2-ERM100 and H4-ERM100. |