Description of Problems / Additions / Changes

Fixed a problem that caused the BX-EBC100 to report Errors or Warnings for their modules in the wrong slot (the slot number is off by one).

Fixed a problem that would prevent the DMIO from quickly recovering if the BRX CPU's network connection to the DMIO was interrupted while being used as an Ethernet I/O slave to a Do-more CPU.

Added support for the following I/O modules:

BX-05TRS-1 - Relay Output (isolated, high current)

BX-08TRZ - Relay Output (dry contact, no suppression)

BX-16TRZ - Relay Output (dry contact, no suppression)

BX-16NF3 - TTL Input 3.5 - 5 VDC (Sink / Source )

BX-16TF2 - TTL Output 3.5 - 5 VDC (Sourcing )

BX-16CF3F2 TTL  Combination 3.5 - 5 VDC (Sink / Source) / 3.5 - 5 VDC (Sourcing )

The EBC100 will now return a 'Module Not Found' error if any of the I/O modules are removed while the EBC100 is powered up.

Fixed a problem where the OK LED was staying YELLOW (not being reset to GREEN ) after fixing I/O errors and warnings in the remote slave.

Fixed a problem with using the -3 Analog and 0xUT modules in a BX-EBC100 that is an Ethernet I/O slave.

Fixed a problem where the module's status bits for -1 and -2B analog output modules were not being reported when used as an Ethernet I/O slave.

This is the minimum firmware and boot loader versions required for BX-EBC100 with Rev 8A hardware.
Requires the use of NetEdit v3.17e or later (this version of NetEdit is installed with Do-more Designer v2.7).

Added support for the following BRX modules:

BX-04UT - 4 Channel Universal Temperature Input
BX-08UT - 8 Channel Universal Temperature Input

BX-04AD-3 - 4 Channel Universal Analog Input
BX-08AD-3 - 8 Channel Universal Analog Input

BX-04DA-3 - 4 Channel Universal Analog Output
BX-08DA-3 - 8 Channel Universal Analog Output

BX-2AD4DA-3 - Combo 2 Channel Universal Analog Input / 2 Channel Universal Analog Output
BX-4AD4DA-3 - Combo 4 Channel Universal Analog Input / 4 Channel Universal Analog Output

BX-4UT4DA-3 - Combo 4 Channel Universal Temperature Input / 4 Channel Universal Analog Output
BX-4UT4TD1 - Combo 4 Channel Universal Temperature Input / 4 Point 24V Discrete Output (Sinking)
BX-4UT4TD2 - Combo 4 Channel Universal Temperature Input / 4 Point 24V Discrete Output (Sourcing)
BX-4UT4TR - Combo 4 Channel Universal Temperature Input / 4 Point Relay Output

Fixed a problem in the web configuration screen for the Combo Voltage Analog modules (BX-4AD2DA-x / BX-2AD2DA-x).

Fixed a problem where the BX-EBC100 was not properly reporting errors and warnings from Analog I/O modules.

Initial Release of the BX-EBC100.

Setup of any analog input or output modules must be done via the Ethernet port (using NetEdit or a web browser) even if using Modbus/RTU (serial) for controlling the I/O.